China High Quality 0014215210 Suppliers

There is no specific replacement cycle for Mercedes-Benz brake discs. When the mileage of the vehicle reaches 100,000 kilometers, the brake disc of the vehicle should be checked. If it is damaged or worn to the limit, it should be replaced in time.

At the beginning of May, the automotive industry received much attention due to the "new energy vehicles going to the countryside" and the "National VI B" emission standard switch. After the five day "May Day" holiday, the domestic car market also saw strong performance.

Tires are like the feet of a large truck, carrying the net weight of the entire body, and are the only small components that the truck touches with the road surface. When describing the intricacy of Tai Chi, there is a saying of "four or two strokes of dry gold", and the small tires can bear more than ten tons or dozens of tons of body weight, which is also the same wonderful! And the tires also rely on the gas filled inside to maintain their support points and cushioning effects. If you're not too meticulous, you can say that a large car is loaded with gas inside the tires! For car enthusiasts, a tire blowout is a big nightmare. I have heard a car enthusiast say that at high speeds, a tire blowout requires 3000 to repair! Therefore, today we will discuss the topic of truck tire pressure with our friends.

The electronic control system in Mercedes Benz pump cars is the most difficult to operate because there are too many functions to operate. Today, I am writing this article to better help everyone master the electronic control system.

​1. Do not start at low temperature and enter full load: When the engine starts at low temperature, the lubrication conditions are at their worst. If the engine starts at full load and the oil temperature is not sufficient to provide the best lubrication, it will cause abnormal damage to the bearing shells, which can easily cause engine sticking for a long time.

​The material of Mercedes-Benz brake discs is ceramic. The brake pads of this material are used because the brake pads of this material have good wear resistance and mechanical strength, as well as their low braking noise. The brake pads are bonded with steel plates and have a heat insulation layer. And the friction block is composed of friction material and adhesive. When braking, it is squeezed on the brake disc or brake drum to generate friction, thereby achieving the purpose of deceleration.